How Do I Hook Up My Car Speakers To An Amp

how do i hook up my car speakers to an amp

How to Connect Speakers With Speaker these wires are correctly connected before powering up and testing the speakers out. Easy Ways to Hook up Most Any Kind. Apr 16,  · Basics of Car Audio (Speakers and (such as the one already located on your amp) and connect the wire to the A prebuilt subwoofer or speaker box (like in my. Jul 02,  · Now it's time to run more wires! Run speaker wires from your speakers to your amp's installation location. Just like with all of the different wires above, be sure they are secured and protected. 6.) Hook up all of the wires at the amplifier! Hook up the RCAs, speaker cables, remote turn on, power then ground. 7.) Hook up a fuse holder Status: Resolved. Not Helpful 3 Helpful 8. If you have a factory deck and install an amp, there's really no wire to connect the amp to on the factory deck. I am using a multiple channel aftermarket head unit, external 4 channel amplifier, and running all new speaker wires to all 4 locations in a vehicle that came with a factory amp. Hope this helps, Geoff. Once you hear distortion, back off a little.

How Do I Hook Up My Car Speakers To An Amp. How To Properly Hook Up Speakers to Amps

How do i hook up my car speakers to an amp -

Is it ok to set it to full? You will also need to power your amplifier in order for it to work. You can put it through an empty rubber grommet in a factory hole. You can purchase instructions on how to remove your radio from Crutchfield at this link. Some receivers have three sets of outputs, some only two. Just Incase it's pertinent, I'm in an 08 avalanche with non Bose equipment. how do i hook up my car speakers to an amp One last thing about amps: If they are, then hook up an external speaker to the radio's output for that side to see if it is the radio at fault. Another question, I have a 15' rockford sub and an amp to go with it, i want to install it into my sentra, but i have found out the stock stereo doesnt come with RCA jacks so whats is the best way to go about this? Put your shiny new terminals on those battery posts! Not Helpful 2 Helpful 8.

4 Comments

Leave a Reply

Your email address will not be published. Required fields are marked *