Mar 03,  · Emer. Ballast Hookup? How long should this have taken per fixture? Owner brought us 10 of these separate emergency ballast to adapt to normal 6 bulb t-8 lights. Owner brought us 10 of these separate emergency ballast to adapt to normal 6 . Hook up and test your mechanism of choice for throwing the switch. This can be a manual ground-throw like the one shown here, or an electric switch machine / motor. Make sure everything works properly before you add any ballast. How to Wire a T8 Ballast. Fluorescent fixtures use ballasts to regulate current. Related Articles. How to Switch From a Magnetic Ballast to an Electronic Ballast; How to Check If the Ballast Is Bad in Fluorescent Lighting ; How to Wire a 3 Lamp Ballast; How to Troubleshoot a Bad Fluorescent Lamp Fixture; A ballast is an electronic device that. Connect the input ballast hook up to the output wires. I have a w HID fixture with multi tap voltage. Not all ignitors or starters are capable of remote operation. The old ballast probably had the black to one lamp and white to one lamp, is this correct? I'm ballast hook up all that "up" on 72's, but are you sure it's supposed to have a ballast resistor? Couldn't have asked for more. Replacing the Ballast on a Fluorescent Light Fixture DIY

Ballast hook up -

My issue is this. In this situation the fixture would be retrofitted for non-shunted T8 LED tubes upon the completion of these steps. I have hooked this thing up every way I could think of and it always dose the same thing. How do I hook the red wire in? Greetings from deep dark Montana.

Ballast Hook Up. Ballast resistor hookup - Pontiac GTO Forum